Solvosol Paints - Products



	15 E & F, Sri Venkateshwara Co-Op. Industrial Estate
	IDA, Jeedimetla, Hyderabad 500055 AP INDIA Ph: +91-40-23091650, 23096104 Fax: +91-40-23097040
	Keyword

SOLVOXY – P2C (SSPL/ZNCR)

SOLVO EPOXY ZINC CHROME PRIMER

	Scope		Areas of Application
	Technical Data		Storage and Handling
	Directions for Use

Scope

A two pack polyamide cured air drying Epoxy composition with red oxide and Zinc Chrome pigments.

Areas of Application

Protection of structural steel, equipments, conveyers, storage tanks, etc. from chemical and saline environment as in fertiliser units, refineries/petrochemical complexes, Hydroelectric projects, Port/off-shore installation, Atomic Energy establishments, chemical processing units, Heavy electrical Engineering units, pulp and Rayan units.

Technical Data

Product Code	432
Colour & Gloss	Redoxide & Matt
Mixing Ratio	Base: Hardener 4:1 (By volume)
Maturation time	30 minutes
Pot life of mixture	6 hours at 30⁰C
Recommended DFT	21.0 sq.m./ltr. at 25 Microns DFT
	17.5 sq.m./ltr.at 30 Microns DFT
Method of Application	Brush/Spray
Thinner Recommended	SOLVO-THIN
Volume of Thinner	Brushing: Nil Spraying: 0-7%
Drying Time	Surface Dry: Approx. 30 minutes at 30⁰C Hard Dry: 16 Hours at 30⁰C
Recoating Period	Minimum: 16 hours Maximum: 48 hours
Compatible finishes	Epoxy, Coal Tar Epoxy, Chlorinated Rubber Vinyl & Polyurethane Coating
Packs Offered	20 & 4 litres

Storage and Handling

Storage	Store in cool dry place.
Shelf Life	Minimum 12 months provided component are unmixed and stored in sealed container.
Disposal	Dispose in land filling and not in drain or any water channel.

Directions for Use

Surface Preparation

Blast clean Mild steel substrate to minimum Sa 2 ½ of Swedish specifications SIS-05-5900-1967 or near white metal of 1477-1971 (Part-I).

If blast cleaning is impracticable, remove loose rust/scale using power tools/hand tools to achieve surface cleaning of St-3 St-2 grade of Swedish specification. Remove contaminates like grease and oil using aromatic solvents. Ensure that surface is clean and dry before priming.

Special Instructions

Primed surface should not be exposed to corrosive environment for a long time without applications of finishing paints.

In case primer coat dries for more than 48 hours, sand papering of primer is essential before application of finishing paints to ensure good inter coat adhesion.

Safety Information
Flash Point
Below 21⁰C

Fire Hazard Class
Flammable

Safety Precaution
Work in a well ventilated place in protective clothing like overalls and gloves.

Home :: Profile :: Products :: Order Form :: Contact Us