Solvosol Paints - Products



	15 E & F, Sri Venkateshwara Co-Op. Industrial Estate
	IDA, Jeedimetla, Hyderabad 500055 AP INDIA Ph: +91-40-23091650, 23096104 Fax: +91-40-23097040
	Keyword

SOLVOTHANE (F3); SSPL/EP-TAR (F3)

	Scope		Areas of Application
	Technical Data		Storage & Handling
	Directions for Use		Special Instruction
	Safety Information

Scope

A two pack air-drying High Build Epoxy Coal Tar coating.

Areas of Application

Specially recommended for protection of mild steel/RCC substrates subjected to continuous water immersion or exposed to marine environment or sub-soil conditions.

Ideal coating for protection of Crest Gates, Sluice gates, Penstocks, Tabular pile, under water structures and pipelines carrying non-potable water. Also, extensively used in irrigation, thermal, hydel projects, port and off-shore installations, shipyards, bridges, etc. This product also has moderate chemical resistance and can be used for protection of conveyors, structural steel, etc., in fertiliser and other chemical processing units.

Technical Data

Product Code	131
Colour & Gloss	Black, Dark Brown & Semi glossy
Mixing Ratio	Base: Hardener, 1:1 (By volume)
Maturation time	30 minutes
Pot life of mixture	8 hours at 30⁰C
Recommended DFT	90-100 Microns per coat
Covering capacity	6.20 Sq.mtr/Ltr. at 100 Microns DFT
Method of Application	Brush/Airless Spray
Thinner Recommended	SOLVOTHIN
Volume of Thinner	Brushing: Air spray: 0.5% (add thinner only if required)
Drying Time	Surface Dry: Approx. 1 hour at 30⁰C Hard Dry: 24 Hours at 30⁰C
Full Cure	Minimum 7 days
Recoating Period	Minimum 16 hours Max. 72 hours
Packs Offered	20 X 4 Litres

Storage & Handling

Storage	Store in a cool dry place
Shelf Life	Minimum 12 months, provided the materials are stored in sealed containers.
Disposal	Dispose in load filling and not in drain of any water channel.

Directions for Use

Surface Preparation

Mild Steel

Blast cleaning to Sa 2 ½ for immersion service.

Power Tool/Mechanical Cleaning to St-3/St-2 is an alternative for non-immersion condition.

Hard wire brushing followed by acid etching with dilute hydrochloric acid followed by thorough washing with fresh water and drying.

Special Instructions

The second coat of this product can be applied after overnight drying of the first coat. However, in case third coat is applied, 48 hours air drying must be allowed for the previous coat.

Safety Information

Flash Point	Below 21⁰C
Fire Point	Flammable
Safety Precaution	Work in well ventilated place. Wear protective clothing like overalls and gloves

Home :: Profile :: Products :: Order Form :: Contact Us